3.10 Burr Seasoning
Please be aware that your grind setting alignment may change after burr seasoning. Static retention will also
be higher than normal until charge is absorbed. This will be reduced after grinding your first 2kg of coffee
through the Varia VS6 and as the body discharges any residual static.
The finger guard, designed to keep fingers away from the sharp burrs, must remain intact. Ensure fingers, loose
clothing, and long hair are kept a safe distance from the hopper opening while operating or on standby.
3.11 Cleaning and Maintenance
Power must be TURNED OFF while cleaning this product. The grinder body and base must NOT be immersed
or submerged in water or washed with water to clean. Cleaning grinder body: Please use a moist cloth/towel
to wipe the body, ensuring that the cloth/towel is not wet, as no water should enter the body. Ensure that once
cleaned, the surfaces are dried again. We recommend you discuss this procedure with your reseller if you are
not familiar or confident in replacing a burr set.
While CHANGING or CLEANING BURRS, make sure the following parts are completely brushed/wiped clean
of ground coffee: Grind chamber, burrs, bearing, upper burr chamber, flat washer and threads on the set
nut, driveshaft, body, and hopper. If NOT brushed clean, an actual 'zero point' may not be attained upon
reassembly, resulting in an inaccurate calibration.
PLEASE NOTE that after replacing a burr set, any performance changes to the grind settings will be a result
of incorrect disassembly and/or reassembly. In this instance, your warranty will not cover any additional costs
related to reinstating the Varia VS6 to factory grind settings and/or performance.
18
DISCONNECT THE POWER SUPPLY by unplugging VS6 from power socket before
cleaning or disassembly .
DANGER!
!
To Next Page
Loading...
