3.1 Removable Dosing Tube with Spring Loaded Knocker
The spring-loaded knocker
interface of the VS6 is
magnetically attached to the
grinder body for easy assembly
and disassembly. It is aligned
using two rails on each side of
the knocker, which correspond
to cut outs on the knocker part.
To disassemble, simply pull the
interface out. To replace, push it
back onto the rails until you feel
the magnets connect.
The VS6 features a removable dosing tube interface,
designed for effortless cleaning. Additionally,
it includes a built-in spring-loaded knocker to
dislodge any loose grounds or static build-up from
the dosing chute. To activate the spring-loaded
knocker, simply pinch the tube and gently pull
it down, then release quickly to allow the tube
to recoil back to its starting position, effectively
knocking the grounds.
Alignment
cut outs
Pinch & gently pull down -
then release to effectively
knock grinds free
09
FINGER SAFETY:
Do not put your fingers into
or up inside grounds chute
when the motor is running or
when the power supply is
plugged in.
DANGER!
!
To Next Page
Loading...
