Varytec Blitz Bar 240 - Sound Control

7.2.4 Sound control
Sound control mode can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via a DMX controller. In this operating mode, the device responds to acoustic pulses
which are recorded by the integrated microphone.
1.
Press to activate the main menu.
2.
Press or until the display shows ‘Mode’ and conrm with .
3.
Press or until the display shows ‘Sound’ and conrm with .
4.
Use or to select the desired show programme ( ‘Pro 00’ … ‘Pro 20’ ) and conrm with
.
ð
The display shows ‘SP’ .
5.
Use or to set the running speed of the programme in a range from ‘Se 01’ (slow) …
‘Se 99’ (fast) and conrm with .
Operating
Blitz Bar 240
27
Stroboscope