Vax DualPower Pro Advance W85-PL-T-E - Maintenance and Cleaning; Emptying the Dirty Water Tank; Removing and Cleaning the Nozzle

11
Emptying the dirty water tank
Removing and cleaning the nozzle
!
CAUTION
!
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
1
Press dirty water
tank release latch,
pull to remove dirty
water tank.
1
Remove both tanks and tilt
carpet washer back. 2
Lift nozzle release clip
and pull nozzle forward,
separating tabs on nozzle
and carpet washer.
3
Rinse nozzle under water to
remove dirt/debris. 4
Replace nozzle by lining up
tabs on nozzle with tabs
underneath front of carpet
washer. Push nozzle down
until it clicks into place.
4
Clean the lter
screen located at
the back of the dirty
water tank.
5
To re-t, tilt dirty
water tank and
line up onto carpet
washer. Push back
until it clicks into
place.
2
Pull and lift dirty
water tank clip to
release lid. Lift to
remove dirty water
tank lid.
3
Empty dirty water
over the sink. Rinse
dirty water tank and
lid under water to
remove dirt/debris.