9
Using the upholstery wash tool
1
Turn wash/rinse dial to
‘wash’. 2
Pull down accessory hose
connector cover. 3
Push hose end and hose
connector into hose and
solution connection port.
4
Slide upholstery tool over tab at end of hose until it clicks into
place. 5
Plug into mains, press the
On/O button to switch on.
NOTE
The carpet washer should be in the upright position when using the upholstery tool, de-activating the SpinScrub brushes
andbrushbar.
To Next Page
Loading...
