7
Filling the water/solution tank
!
IMPORTANT
!
Your dirty water tank is tted with a oat. When the dirty water tank is full, or the oorhead is not in contact with the carpet the oat will shut o the suction on the carpet
washer. You will be able to hear if this has happened as the motor noise on the machine will increase. Once the oat is activated, empty the dirty water tank if full. If the
dirty water tank is not full then turn o your machine at the power switch and wait for the oat to settle.
!
CAUTION
!
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
TIP - This machine has an auto mix tank so any solution not used can be poured back into the bottle.
1
Press clean water/solution
tank release button, pull and
lift to remove tank.
5
Tilt clean water/solution
tank and line up onto carpet
washer. Push tank back until
it clicks into place.
2
Twist solution tank cap
anti-clockwise and remove.
6
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar deep
clean your carpets with
water and solution removing
dirt and stains.
4
Fill the clean water tank with
warm water (max 40’C).3
Pour required amount of
carpet cleaning solution into
tank. Tighten cap before
returning tank to unit.
7
Plug into mains, press the
On/O button to switch on.
To Next Page
Loading...
