Vax DualPower Pro Advance W85-PL-T-E - Operating Your Carpet Washer; Using the Pre-treatment Wand

8
Operating your carpet washer
Using the pre-treatment wand
2
Squeeze the trigger
to release solution
and water mix.
3
For best results
apply water/solution
on the forward
stroke and release
the trigger to pick up
water/solution on the
backward stroke.
5
Turn wash/rinse dial
to ‘rinse’. Only water
is released to remove
solution residue.
4
Press the boost
trigger to remove
tough stains.
1
Press the recline
pedal and pull handle
backwards.
1
Turn wash/rinse dial to
‘wash’. 2
Pull down accessory hose
connector cover. 3
Push wand connector into
solution tube port. 4
Plug into mains, press the
On/O button to switch on.
5
Press and hold trigger
onpre-treatment wand,
spraying evenly over
stubborn stains.
6
Leave the solution for
10-15minutes before
washing carpet.
Pre-treating your carpet before
washing will help to remove
stubborn stains. Do not saturate
your carpet.
NOTE
The carpet washer should be in the upright position when using the hose or pre-treatment wand;
de-activating the SpinScrub brushes and brushbar.
15