27
7 8
Emptying the dirty
water tank
Return dirty water tank to the base
of the cleaner by tipping the nozzle
d
own into the basin and dropping it
into place.
Lift the front of the cleaner base off
the carpeting with one hand. Line
u
p the black tabs with the grooves
of the front nozzle. Lift the front
nozzle upwards towards the cleaner
and press under the latch until it
locks into place.
26
Post-treating your carpets
with the carpet wand and
post-treatment solution
1
N.B The carpet treatment wand will
need priming before using to allow
the correct solution to r
un through.
Holding o
v
er the sink, depress the
trigger for approximately 20
seconds. The wand will then to
ready f
or post-treatment.
Remove the clean water tank by
pressing the clean water tank
release and pulling the tank by the
handle. Put to one side to fill later.
2
3
While the clean water tank is
removed, loosen the solution tank
by gently pushing out the solution
plug from the plug opening.
Note:
The solution tank can be
filled while it is attached to the
cleaner but you should use care
when refilling.
Remove the solution tank by pulling
up and out.
Note: After spraying rinse the
machine and carpet treatment
w
and with clean w
ater
.
Wash the
car
pet as described in this guide,
using VAX AAA carpet cleaner.
V027(Y) User Guide 5/10/06 11:47 am Page 13
To Next Page
Loading...
Need help?
General
