100 © Continental Automotive Issue 10/2019
Always keep the drawer printer closed.
We recommend only opening the drawer at the time
of paper change.
Remove, if necessary, the old paper roll and place a new one according to figure
below.
In cases of pre-printed paper roll, make sure that the gray stripe is inside the
drawer, after its closure.
For standard application, make sure the paper is not
trapped when placed in the drawer and prepress is
with the side up and ensuring that the tape gray stripe
is positioned correctly, see figure above.
Stop
As a thermal printer, in case of a printing sequence it can heat
up, causing the user to run the risk of burning itself in case of
direct contact.
To Next Page
Loading...
