13
4.1.8 Selection of the displays
(screens on / off)
Select here which measured values are to be displayed in the normal operating
mode.
YES: Here all measured values, with their ISO symbol, are displayed.
By selecting NO the measured value can be removed from the
normal operating mode.
If the measured value is to be displayed again, select YES when
the ISO symbol of the measured value is displayed.
NO: No changes in the setting are made.
4.1.9 Activation of the simulation mode
(simulator mode)
Select here whether the simulation mode is to be switched on.
YES: The simulation mode is switched on. The display now generates
random values for all measuring channels and displays these. The
measured values are also transmitted to the bus instruments.
NO: The simulation mode is switched off.
Please note that the simulation mode still remains active after switching off and
switching on again, if it has not been switched off by selecting NO.
4.1.10 Ending the settings
(exit setup)
Select here whether the settings are to be exited.
YES: The settings are exited, the display restarts in the
normal operating mode.
NO: The settings are restarted.
To Next Page
Loading...
