5
2. INSTALLATION INSTRUCTIONS
2.1 GENERAL INSTALLATION NOTES
Please read the entire installation instructions to get
familiar with the installation steps before installation.
Be very careful when installing the batteries, especially
flooded lead-acid battery. Please wear eye protection,
and have fresh water available to wash and clean any
contact with battery acid.
Keep the battery away from any metal objects, which
may cause short circuit of the battery.
Explosive battery gases may come out from the battery
during charging, so make sure ventilation condition is
good.
Ventilation is highly recommended if mounted in an
enclosure. Never install the controller in a sealed
enclosure with flooded batteries! Battery fumes from
vented batteries will corrode and destroy the controller
circuits.
Loose power connections and corroded wires may result
in high heat that can melt wire insulation, burn
surrounding materials, or even cause fire. Ensure tight
connections and use cable clamps to secure cables and
prevent them from swaying in mobile applications.
The controller can work with lead-acid battery and lithium
battery within its control scope.
Battery connection may be wired to one battery or a bank
of batteries. The following instructions refer to
a singular
battery, but it is implied that the battery connection can be
To Next Page
Loading...
Need help?
General
