Vega VEGADIF 85 - Sensor Setup with Display and Adjustment Module; Display and Adjustment Module Insertion

34
6 Set up the sensor with the display and adjustment module
VEGADIF 85 • Modbus and Levelmaster protocol
53571-EN-230814
6 Set up the sensor with the display and
adjustment module
6.1 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
andremovedagainatanytime.Youcanchooseanyoneoffourdier-
entpositions-eachdisplacedby90°.Itisnotnecessarytointerrupt
the power supply.
Proceed as follows:
1. Unscrew the housing lid
2. Place the display and adjustment module on the electronics in the
desired position and turn it to the right until it snaps in.
3. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
Fig. 32: Insertion of the display and adjustment module
Note:
Ifyouintendtoretrottheinstrumentwithadisplayandadjustment
module for continuous measured value indication, a higher lid with an
inspection glass is required.