Vega VEGADIF 85 - Parameter Adjustment: Quick Setup; Parameter Adjustment: Extended Setup

37
6 Set up the sensor with the display and adjustment module
VEGADIF 85 • Modbus and Levelmaster protocol
53571-EN-230814
With the " [->]" button, you can select the requested language, with "
OK"youconrmtheselectionandmovetothemainmenu.
You can change your selection afterwards with the menu item " Setup
- Display, Menu language".
6.4 Parameter adjustment - Quick setup
To quickly and easily adapt the sensor to the application, select the
menu item " Quick setup" in the start graphic on the display and
adjustment module.
Select the individual steps with the [->] key.
After the last step, " Quick setup terminated successfully" is displayed
briey.
The return to the measured value indication is carried out through the
[->] or [ESC] keys or automatically after 3 s
Note:
Youcanndadescriptionoftheindividualstepsinthequicksetup
guide of the sensor.
Youcannd"Extended adjustment" in the next sub-chapter.
6.5 Parameter adjustment - Extended adjustment
For technically demanding measuring points, you can carry out
extended settings in " Extended adjustment".
Themainmenuisdividedintovesectionswiththefollowingfunc-
tions:
Setup: Settings e. g. for measurement loop name, application, units,
positioncorrection,adjustment,signaloutput,disable/enableopera-
tion
Display: Settings, e.g., for language, measured value display, lighting
Main menu