Vega VEGADIS 81 - Setup with Display and Adjustment Module; Module Installation and Adjustment System

23
6 Set up with the display and adjustment module
VEGADIS 81 •
43814-EN-170913
6 Set up with the display and adjustment
module
6.1 Short description
The display and adjustment module is used for measured value
display, adjustment and diagnosis. It can be mounted in the following
housing versions and instruments:
•
All continuously measuring sensors in single as well as double
chamber housing version (optionally in the electronics or terminal
compartment)
•
External display and adjustment unit
Note:
Youcannddetailedinformationonadjustmentintheoperating
instructions manual "Display and adjustment module".
6.2 Insert display and adjustment module
The display and adjustment module can be inserted into VEGADIS
81 and removed again at any time. It is not necessary to interrupt the
power supply.
Proceed as follows for mounting the display and adjustment module:
1. Unscrew the housing lid
2. Place the display and adjustment module in the desired position
ontheelectronics(youcanchooseanyoneoffourdierentposi-
tions - each displaced by 90°)
3. Press the display and adjustment module onto the electronics
and turn it to the right until it snaps in
4. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
Function/Conguration
Mount/dismount display
and adjustment module