__________________________________________________________________________________________________________________________________________________________
5
ASSEMBLY OF THE MAIN PCB P8010:
Foreword:
For best results and easy handling of the large PCB (Printed Circuit Board), we will start by putting the
four large valve sockets in place. This will allow us to rest the board on the bench, without having the
component leads touching the bench surface.
When the component leads are put in the appropriate holes on the PCB, we recommend to gently bend
the leads outwards, so they stay on the board when it is flipped over to apply solder. You gain a reason-
able amount of time if you put approx. 10 components in place every time, before you flip the board,
and make the solder joints.
To Next Page
Loading...
