Installation – Quick Start
8
.
www.velodyne.com
Digital Drive User’s Manual
To set up and take advantage of the EQ features in your new Digital Drive subwoofer in the least
amount of time, perform the following steps:
1. Unpack the subwoofer and connect the power cable.
2. Connect an LFE input cable from your receiver/processor to the input jack.
For other hookup options, see step 2, below.
3. Power up the unit and ensure that it is receiving signal from your receiver
(i.e. playing bass).
4. Connect the microphone (in the accessory kit) and place it in your favorite listening
position. Then press 3-2-1 on the remote.
5.
The unit should emit 25 “sweep” tones then restart and play normally.
6. Adjust the subwoofer’s volume to taste.
7. Enjoy!
To Next Page
Loading...
Need help?
General