Velux KLR 100 Directions For Use

30 31
7
8
9
Enter
Stop position
0%
Back
--- SET TIMER ---
Enter Back
--- SET TIMER ---
Enter Back
--- SET TIMER ---
Menu
No. 1
Window
Room 1
Locate
P1
P2
P1
P2
P1
P2
10
Menu
No. 1
Window
House
Back
Enter
--- MENU ---
Back
Keypad lock
Timer
Settings
Enter
Start position
100%
Back
-- SET TIMER --
P1
P2
P1
P2
Enter
-- TIMER --
Back
Set timer
Delete timer
P1
P2
2
3
4
5
1
Enter Back
Room 1
--- WINDOW ---
No. 1
6
Press to set the desired start position of the
window when activated via the timer.
100% corresponds to fully open.
Press
"Enter" to confirm the setting.
Press
to set the stop position of the window
when deactivated via the timer. 0% corresponds
to fully closed.
Press
"Enter" to confirm the setting.
Press
to choose the time period required.
First choose minutes.
Press
"Enter" to change to hours.
Press
to choose hours. The window is now set
to close after 1 hour and 10 minutes.
Press "Enter" to confirm the setting.
The display shows that the timer has been acti-
vated.
Window No. 1 in Room 1 now closes after 1 hour
and 10 minutes.
Note: The timer can be interrupted by choosing
"Delete timer" in item 3.
Time period
00h 10 min
Time period
01 h 10min
Timer
With the timer you can for example close a win-
dow, roll down a sunscreening product or turn off
frame lights after a pre-set time interval.
The example shows how to set window No. 1 in
Room 1 to close after 1 hour and 10 minutes.
Press
"Menu".
Press
to highlight "Timer".
Press “Enter” to confirm your choice.
Press
to highlight "Set timer".
Press "Enter" to confirm your choice.
Locate the window, see section Locating and oper-
ating a product.
The display shows the relevant product. The indi-
vidual products can be identified by pressing
for a short period of time.
Press
"Enter" to proceed.

Velux KLR 100 Specifications

General

Product type	Remote Control
Frequency	868 MHz
Power source	Battery
Compatibility	VELUX INTEGRA products
Range	300m (open air)
Battery Type	2 x AA Alkaline
Operating Range	Up to 30m indoors