VEMAG ROBOT HP7C - Machine Operation; Working with the Machine

5. OperationROBOT HP7C / HP10C / HP15C / HP17C
5-1© VEMAG 2004
5. Operation
5.1 Working with the machine
To start production with the machine, proceed as follows:
• Set up the machine for the product to be filled
Section 4
• Switch on the main switch of the machine.
• Press the ON switch on the machine control panel.
Danger!
You must check that any safety devices fitted to the hopper and the step
are working properly.
• Unlock the hopper and tip it open.
• Fold out the step.
• Remove the filling horn holder.
In each of the cases described, the machine must switch off automatically.
If the machine does not switch off, work may not continue with the
machine. In this case, inform VEMAG Customer Service immediately.
• Pull on a casing suitable for the product to be filled.
• Push the trolley containing product into the trolley hoist of the lifting/
tipping device up to the stop. The locking lever must lock and hold the
trolley securely in the trolley hoist.
• Press the UP key of the lifting/tipping device to move the trolley over
the hopper with the trolley hoist. The trolley is automatically emptied
into the hopper.
Danger!
Make sure that there is no-one in the area of the lifting/tipping device
during operation and that no objects have been deposited there.
• Press the DOWN key to lower the trolley again. The trolley hoist stays
approx. 500 mm above the floor. Press the DOWN key again and keep
it depressed until the trolley has reached the floor.