VEMAG ROBOT HP7C - Cleaning Schedule and Lubrication

6. CleaningROBOT HP7C / HP10C / HP15C / HP17C
6-11© VEMAG 2004
Cleaning agent
water
free of activated chlorine,
alkaline, concentration
depending on degree of
contamination – as low as
possible – and in accordance
with manufacturer’s
instructions
free of activated chlorine,
acid, concentration depending
on degree of contamination –
as low as possible – and in
accordance with
manufacturer’s instructions
drinking water
disinfectant free of activated
chlorine, concentration as low
as possible and in accordance
with the manufacturer’s
instructions
drinking water
oil which is safe for food use
Process
• by hand,
mechanically
• water jet max. 25
bar, temperature
max. 60 °C,
depending on fat
softening point
• visual
• foam or clean by
hand, leave to act
for approx. 15
minutes
• foam or clean by
hand, leave to act
for approx. 15
minutes
• water jet max. 25
bar, temperature
50 to 60 °C
• visual
• spray, foam, leave
to act in
accordance with
manufacturer’s
instructions
• water jet max. 25
bar
• spray
Notes
Begin as soon
as production
finishes
Clean small
parts at the
same time
Carry out
daily, clean
small parts at
the same time
Frequency as
required
Whole
machine and
small parts
Pay special
attention to
feed system,
small parts
Whole system
and small
parts
Rinse off in
accordance
with Meat
Hygiene
Order,
Appendix 2, II,
4
Particularly
feed system
Equipment
plastic spatula,
scraper
(Schlesinger)
low-pressure
equipment, hose
low-pressure foam
equipment (max. 25
bar), hand spray,
brush, bowl
low-pressure foam
equipment (max. 25
bar), hand spray,
brush, bowl
low-pressure
equipment (max. 25
bar), hose
low pressure
equipment (max. 25
bar), hand spray
low-pressure
equipment (max. 25
bar), hose
hand spray
Cleaning task
Rough cleaning,
removal of product
residues (if
necessary, remove
small parts first)
Thorough initial
rinse
Visual check of
cleanliness
Alkaline cleaning
or:
Acid cleaning to
remove lime
deposits
Rinse
Visual check of
cleanliness
Disinfect (after all
the cleaning
measures in the
room have been
completed)
Rinse off
Dry and oil
6.4 Cleaning schedule
All details refer to single-shift operation.