3/2002
PC-7
SET-UP AND CODE DESCRIPTION (CONTINUED)
Test Mode
If selection button one is pressed at the “tESt” prompt, the controller will enter the Test
Mode. Upon entry into the test mode the display will show the first summary test, “CO 1”.
Pressing selection button one or two will toggle through the column selections. Pressing
selection button three will test vend the displayed column. In order to exit the setting, press
the service mode button or close the outer door.
tESt
Test Lights
If the fifth selection button is pressed at the “tESt” prompt, the “LItE” mode is displayed. If
the fifth button is pressed again at the “LItE” prompt, the controller will activate the test
status of the lights. Pressing the fifth button again de-activates the test status of the lights.
ItE
Compressor Test Mode
If the sixth selection button is pressed at the “tESt” prompt, the “CnPr” mode is displayed. If
the sixth button is pressed again at the “CnPr” prompt, the controller will activate the test
status of the compressor. Pressing the sixth button again de-activates the test status of the
compressor.
nPr
Cost Setting Mode (Multi-Price)
The purpose of this mode is to enable the controller to set the vend price for each of the
selections. If selection button one through ten is pressed at the “COSt” prompt, the display
will toggle “SL X” “00” (“X” will indicate the selection buttons and “00” will indicate the
selection price). Pressing the same button again will increase or decrease the price. In
order to save the selection price, either press the service mode button or close the outer
door.
OSt
Cost Setting Mode (Single-Price)
The purpose of this mode is to enable the controller to set the vend price for each of the
selections. If selection button one is pressed at the “COSt” prompt, the display will toggle
“SPRl” “00” (“00” will indicate the selection price). Pressing the same button again will
increase or decrease the price. In order to save the selection price, either press the service
mode button or close the outer door.
Note: Make sure 1.4 is set properly in configuration group 1 mode.
Example: 1.4 “y” = Single price enabled / Multi-price disabled.
1.4“n” = Multi-price enabled / Single price disabled.
To Next Page
Loading...
Need help?
General
