3/2002
PC-12
SET-UP AND CODE DESCRIPTION (CONTINUED)
Hour Setting Option
If selection button two is pressed at the “Hour” prompt, the display will show the current
hour. By pressing selection button one the controller will allow you to increase or decrease
the hour setting. Pressing selection button three will return to the “Hour” prompt and save
the current setting.
Hour
Daylight Savings Time
If selection button two is pressed at the “dSt” prompt, the display will show the current
Daylight Savings Time. Pressing and releasing selection button one will toggle the different
countries; AUS (Australian rules), EU (European rules), OFF (No daylight savings) and NA
(North American rules). Pressing selection button three will return to the “dSt” prompt and
save the current setting.
dSt
Block Selection Setting
This feature is used to choose a group of selections and the time when those selections will
be blocked from vending product. If selection button one is pressed at the “bLC1” or “bLC2”
prompt, the controller will enter the Selection Blocking Control Mode. Upon entry into this
program, the display will show the first sub-mode “CtL1”.
bLC1
Using selection button one will also let the operator toggle between the following modes:
BLOCK SELECTION OPTIONS
“CtL1” Controls bLC1 option
“SbL1” Set selection group 1 option
“Str1” Set start time
“dAY” Set days to time
“Hour” Set time to start (24 hours) - see above
“StP1” Set stop time
“dAY” Set days to time
“Hour” Set time to start (24 hours) - see above
Pressing selection button two will save the currently displayed setting and return the user to
the “CtL1” prompt. Pressing selection button three will return to the “bLC1” prompt without
saving.
To Next Page
Loading...
Need help?
General
