What to do if the LED of my Venmar Fan is blinking red?
If the LED of the integrated control on your Venmar Fan is blinking red because the door is open, close the door and press the integrated control push button once to reset the unit. If the LED is blinking red because there is a problem with the exhaust motor, contact your installer.
Why is there condensation on my windows when using Venmar Fan?
To reduce condensation with your Venmar Fan: leave curtains half-open to allow air circulation; store all firewood in a closed room with a dehumidifier or in a well-ventilated room, or store the wood outside; do not adjust the thermostat of your heating system below 18°C (64°F).
What to do if air from Venmar Fan is too cold?
If the air is too cold at the air supply grille of your Venmar Fan, check if the exterior hood is not blocked and install a duct heater.
Why is the LED of my Venmar Fan blinking amber?
If the LED of the integrated control on your Venmar Fan is blinking amber because there is a problem with the motorized damper, the unit will try to reset the damper every 20 to 30 minutes for a 12-hour period. After 12 hours, if the problem is not solved, the unit stops trying to reset the damper. Contact your installer.
What does it mean when the LED of Venmar Fan is blinking green?
If the LED of the integrated control on your Venmar Fan is blinking green because there is a problem with the thermistor, contact your installer.
Why is the supply motor not working on my Venmar 41504?
If the supply motor in your Venmar Air Conditioner isn't working while the exhaust motor is, there could be several reasons. The supply motor itself, its capacitor, or the PCB might be defective. Also, check if the door is open (and the unit isn't unplugged), or if there's a loose connection in the 18 µF low-speed capacitor wires, or a loose connection between the blue wire from the J9 connector to the blue wire from the transformer. To troubleshoot, try these steps: * Plug the supply motor into the J5 connector and the exhaust motor into the J4 connector. If the integrated control LED flashes RED, the supply motor is defective. If the exhaust motor works, plug the supply motor back into the J4 connector and the exhaust motor into the J5 connector, then check the supply motor capacitor....
Describes the unit's booting sequence and integrated control operation.
Steps to prepare the unit before installation.
Guidance on choosing an appropriate location for the unit.
Specific considerations for installing the unit in an attic.
General guidelines for installing ductwork and registers.
Instructions for installing exterior hoods, including warnings.
Instructions for connecting optional wall controls to the unit.
General| Brand | Venmar |
|---|---|
| Model | 41504 |
| Category | Air Conditioner |
| Language | English |
To Next Page
