To Next PageTo Next PageWhat to do if Venstar T1050 Thermostat air conditioning repeatedly tries to turn on but fails?
If your Venstar Thermostat's air conditioning equipment attempts to turn on repeatedly but is unsuccessful, it may be due to insufficient power for "power sharing". The suggested solution is to connect a 250 ohm, 10 watt power resistor at the furnace as shown in the manual.
General| Brand | Venstar |
|---|---|
| Model | T1050 |
| Category | Thermostat |
| Language | English |
Details the main screen with Thermoglow.
Explains the function of Mode, Fan buttons, and Heat/Cool indicator.
Describes mode symbols, clock, day, room temp, and setpoints.
Covers Day Part, Setup, Fan On, and Locked icons.
Basic steps to set the current time and day.
Explains Heating, Cooling, Auto, Program, and Off modes.
How to change heat and cool set temperatures in different modes.
How to use the Fan button for continuous or automatic fan operation.
Configures start times and temperatures for three periods.
Configures start time and temperatures for the Night period.
Accessing setup, setting time, day, and system type (HP/Gas).
Adjusting polarity, electric heat, deadbands, and differentials.
Configuring cycles per hour, backlight, and temperature units.
Explains calibration procedure and deadband operation effects.
Details Emergency Heat activation and Electric Heat function.
Covers Factory Defaults reset and Keypad Lockout.
Details the limited warranty, its coverage, and exclusions.
