Venstar T1050 - Quick Start Guide; Setting Clock and Day

Press the MODE and FAN
buttons at the same time
for two seconds to enter
Setup screens.
Press the MODE
and FAN buttons
at the same time
t o r e t u r n t o
normal operation.
Quick Start Set the Clock and Go
The thermostat is preprogrammed from the factory to operate
one or two stage equipment* without the need for further
programming. To optimize the installation of this thermostat,
follow the instructions in the Advanced Setup section.
* The thermostat is not preprogrammed from the factory to operate
electric heat or heat pump systems. To control these systems,
follow the steps in the Advanced Setup section, pages 11 & 12.
Press
MODE
Setting the Clock
Setting the Day
Am
Setup
I2:00
SetupMo
During Setup & Programming:
Pressing the UP or DOWN
butt ons will modify th e
flashing selection.
To adjust the
Clock or Day use
Tip: To change hours quickly,
press and hold the FAN
button and press the UP or
DOWN buttons.
buttons.
MODE FAN
MODE FAN
Page 5