To replace the air filter:
Open the air filter cover and remove the old air filter. The air filter is not
washable or reusable.
Place a new air filter then close the air filter cover.
Make sure the air filter is fitted at all times to prevent water and dust from
entering the device.
3. Check the air tubing and replace it if there are any holes, tears or cracks.
When the water tank and air tubing are dry, can begin to reassemble the parts.
1. Connect the air tubing firmly to the air outlet located on the rear of the device.
2. Fill the water tank with distilled room temperature water up to the maximum
water level mark.
3. Put water tank into the device. Close the water tank cover.
4. Connect the free end of the air tubing firmly onto the mask.
The device records therapy data for you and your care provider so they can view
and make changes to your therapy if required. The data is recorded via a SD card.
You can send SD card to your care provider by mail. When instructed by your care
To Next Page
Loading...
