OPERATIONAL CONTROLS
Operation - 19
OPERATIONAL CONTROL LOCATIONS
The images on the previous page match with ref-
erence letters as shown below to help identify the
locations of operational controls for this power unit.
A - PTO Switch
B - Ignition Key Switch
C - Throttle
D - Volt Gauge
E - Tachometer/Hour Meter
F - Engine Oil Pressure Warning Light
G - Seat Belt Light
H - Light Switch
I - 12 Volt Switch (On/Off)*
J- 12 Volt Switch (Momentary On/Off/On)*
K - Choke
L - Selector Lever/Parking Brake
M - Belt Tension Lever
N - Front Hitch Latch Lever
O - Front Hitch Lock
P - Seat Slide Adjustment Lever
Q - High/Low Range Shift Handle
R - Weight Transfer*
S - Fuel Shut-off Valve
T - Primary S.D.L.A. Control
U - Secondary S.D.L.A. Control
V - Foot Pedal*
W - 12 Volt Rear Outlet & 4-Pin Socket*
X - 3pt Hitch Control Handle*
Y - Left Rear Auxiliary Hydraulics Handle*
Z - Right Rear Auxiliary Hydraulics Handle*
AA - Auxiliary Hydraulic Quick Couplers
BB - 12 Volt 4-Pin Socket*
CC - Electric PTO Remote (5-Pin Socket)*
DD - Seat Latch (See page 18)
EE - Seat Prop (See page 18)
FF - Seat Lock Lever* (See page 18)
* Optional Equipment
POWER TAKE OFF (PTO) SWITCH (A)
Depressing the top of the PTO switch engages the
electric clutch to provide power to the front attach-
ment. Depressing the bottom part of the switch will
disengage the clutch and apply the clutch brake to
stop the attachment. Note: The PTO will shut off
automatically if the operator leaves the power unit
seat. To restart, fi rst return to the seat, then disen-
gage and re-engage the PTO switch.
IGNITION KEY SWITCH (B)
1
2
3
1. Off or Stop Position - All 12 volt power going
through the key switch is off.
2. On or Run Position - Engine run position.
3. Start - When key is turned to the start position,
starter will engage.
THROTTLE (C)
Moving the lever forward increases the engine
Revolutions Per Minute (RPM). Moving it back slows
the engine to an idle.
VOLT GAUGE (D)
Displays the voltage level of the charging system.
TACHOMETER & HOUR METER (E)
When the engine is running, the engine RPM is dis-
played. When the engine is not running, the engine
run time in hours is displayed.
ENGINE OIL PRESSURE WARNING LIGHT (F)
Signifi es low or no engine oil pressure.
SEAT BELT LIGHT (G)
Light indicates when seat belt is not in use. When
seat belt is fastened, the light will turn off.
To Next Page
Loading...
