EasyManua.ls Logo

Ventrac 4100 - Servicing Air Filter Elements

Ventrac 4100
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service - 32
8. Remove oil lter (B) located in front of the left
side of the engine. Turn lter counterclockwise to
remove.
9.
B
B
Wipe the lter mounting surface with a clean
cloth.
10. Apply a thin lm of clean engine oil to gasket of
oil lter.
11. Install new lter. NOTE: Turn lter clockwise
until lter gasket makes contact with the mount-
ing surface. Tighten 1/2 - 3/4 turn after gasket
contact.
12. Install oil drain cap. DO NOT over-tighten.
13. Remove oil ll cap.
14. Add oil to engine. (See Engine Owner’s Manual
for proper oil and capacity)
15. Install oil ll cap.
16. Start engine and allow to run at slow idle for ap-
proximately 2 minutes.
17. Shut off engine.
18. Remove ignition key from switch.
19. Check oil after allowing engine to cool for ap-
proximately 2 minutes.
20. Refer to “Checking Engine Oil Level” for proper
procedures on how to check the oil.
SERVICING AIR FILTER ELEMENTS
AVOID ENGINE DAMAGE!
When removing the air lter element, an open-
ing directly to the internal parts of the engine is
created.
Be sure that nothing falls into the canister that
could make its way into the engine. Have the new
lter element ready to install immediately after the
old element has been removed.
ATTENTION: Avoid damage to your
engine! Improper service to the engine air
lter can result in severe engine damage.
• Inspect lter daily in extreme heat, dust,
or other severe conditions.
Never run engine without proper air lter
installed.
Never wash or clean paper lter element.
Changing Air Filter Element(s)
1. Park power unit on a level surface.
2. Engage parking brake and shut off engine.
3. Remove ignition key from switch.
4. Allow engine to cool.
5. Open engine hood to access engine compart-
ment.
6. Release both latches (A) on the canister and
unhook latches from the canister housing.
7.
A
A
A
A
B
B
C
C
Remove the air lter cap (B).
8. Remove and discard the primary lter element (C).
9. If necessary, remove and discard the inner safety
air lter element. Refer to Maintenance Schedule
for safety air lter service interval.
SERVICE

Table of Contents

Related product manuals