PaymentCloud LLC. • 800-988-2215 • support@paymentcloudinc.com
3
V.032025
Verifone MX925
User Manual & Setup Guide
Spec Sheet
Shop Verifone MX925
Power & Set Up
1. Connect your Ethernet cable to your device’s auxiliary module
(the cable is connected via the leftmost RJ45 port on the back
of the device).
2. Plug your module into the open compartment on the back of
your Verifone Mx925.
3. Next, plug your 12v power cable into your Mx925’s power port.
4. Ensure that your power cable is plugged into a working power
source.
5. Your Verifone Mx925 should begin powering on shortly.
Note: An ACTIVATION CODE will appear on your screen after
powering on. Merchants are advised to save this code for when they
have to activate their terminal.
How to Load Paper Roll
The Verifone MX925 lacks a built-in printer. Therefore, thermal
receipt paper rolls cannot be loaded into it.
How to Turn On/Off
• Power ON: Your device will power on when you plug your 12v
power cable into the matching 12v power port (as well as a
working external source).
• Power OFF: Disconnect your Verifone Mx925 from its power
source.
How to Set Up an Ethernet Connection
Upon plugging your Mx925 cables into their requisite ports, your
device should connect to the network. For connection instructions,
see the POWER & SETUP section of our guide.
How to Enter System Mode
1. Press the 1, 5, and 9 keys at the same time.
2. Select CONTROL PANEL, then SYS MODE.
3. When prompted, enter the supervisor password (either 166832
or 166831).
4. You are now in SYSTEM MODE.
Verifone Mx925 - Default Password
The default password for the Verifone MX925 is 9416557. The
password required for merchants to enter SYSTEM MODE is either
166832 or 166831. To reset your password, visit the RESET YOUR
PASSWORD page at Verifone.com.
Setup
Setup
3
Accept Payments
4
Rights Reserved
11
Settings
7
Troubleshooting
& Tips
8
Overview
2
To Next Page
Loading...
