12
From the Main_Menu > Settings > Alerts > Email view, use the following
commands to enter the SMTP server name and the email addresses for
appliance failure alerts.
Email SMTP Add Server [Account]
[Password]
The Server variable is the host name of the target SMTP
server that is used to send emails. The [Account] option
identifies the name of the account that was used or the
authentication to the SMTP server. The [Password]
option is the password for authentication to the SMTP
server.
Enter the SMTP server name
Email Software Add Addresses
Where Addresses is the user's email address. To define
multiple emails, separate them with a semi-colon.
Enter email addresses
13
Set the role for the appliance to a master server.
From the Main_Menu > Appliance view, run the following command:
Master
14
After you set the role configuration, the disk storage prompts appear for the
NetBackup Catalog, AdvancedDisk, and MSDP partitions.
To configure storage partitions, you must do the following:
■ Enter a size for the NetBackup Catalog on the master server.
To skip the configuration for the NetBackup Catalog partition, enter 0 when
prompted for its size. To keep the partition at its current size, press Enter.
■ Enter a storage pool size in GB or TB.
To skip the storage pool size configuration for any partition, enter 0 when
prompted for its size. To keep the storage pool at its current size, press
Enter.
■ Enter a disk pool name.
The default names are dp_adv_<hostname> for AdvancedDisk and
dp_disk_<hostname> for MSDP. To keep the default names, press Enter.
■ Enter a storage pool name.
The default names are stu_adv_<hostname> for AdvancedDisk and
stu_disk_<hostname> for MSDP. To keep the default names, press Enter.
The storage prompts appear in the following order:
56Initial configuration procedures
Performing the initial configuration on a 52xx master server appliance from the NetBackup Appliance Shell
Menu
To Next Page
Loading...
Need help?
General
