With this step, NetBackup is re-configured to operate with the new host name.
This process may take a while to complete.
For the command Hostname set to work, at least one IPv4 address is required.
For example, you may want to set the host name of a specific host to v46. To
do that, first ensure that the specific host has at least an IPv4 address and
then run the following command.
Main_Menu > Network > Hostname set v46
10
In addition to the above network configuration settings, you may also use the
Main_Menu > Network view to create a bond and to tag a VLAN during the
initial configuration of your appliance network.
■ Use the Network > LinkAggregation Create command to create a bond
between two or more network interfaces.
■ Use the Network > VLAN Tag command to tag a VLAN to a physical
interface or bond interface.
For detailed information about the LinkAggregation and the VLAN command
options, refer to the NetBackup Appliance Command Reference Guide.
11
From the Main_Menu > Network view, use the following commands to set the
time zone, the date, and the time for this appliance:
■ Set the time zone by entering the following command:
TimeZone Set
Select the appropriate time zone from the displayed list.
■ Set the date and the time by entering the following command:
Date Set Month Day HHMMSS Year
Where Month is the name of the month.
Where Day is the day of the month from 0 to 31.
Where HHMMSS is the hour, minute, and seconds in a 24-hour format.
The fields are separated by semi-colons, for example, HH:MM:SS.
Where Year is the calendar year from 1970 through 2037.
55Initial configuration procedures
Performing the initial configuration on a 52xx master server appliance from the NetBackup Appliance Shell
Menu
To Next Page
Loading...
Need help?
General
