Verizon ASK-SFE116 User Manual

LTE Network Extender User Guide
Verizon LTE Network Extender User Guide v1.7
© 2020 Verizon. All Rights Reserved.
25
Mode
Mode IPv4 or IPv6 mode.
DHCP DHCP is enabled by default. When enabled, IP configuration is provided by the local
DHCP server. When disabled, specify a static IP configuration for the Network
Extender manually.
IPv4 / IPv6
Default Gateway Displays default gateway IP address. When DHCP is disabled, enter the default
gateway IP address here.
IP Address Displays local IPv4/IPv6 IP address of the Network Extender. When DHCP is disabled,
enter the IPv4/IPv6 address here.
Subnet Mask Displays subnet mask of the Network Extender. When DHCP is disabled, specify a
subnet mask here.
Primary DNS Displays the primary DNS server IP address. When DHCP is disabled, enter the primary
DNS server IP address here.
Secondary DNS Displays the secondary DNS server IP address. When DHCP is disabled, enter the
secondary DNS server IP address here.
IPv6 Each item of IPv6 setting is just for the Link-local address
MTU Size Maximum Transport Unit (MTU) defines the maximum packet size for data
transmission over the network. The default setting is recommended. When set too
high, users may experience poor voice quality and increased latency. If set too low,
overall bandwidth consumption will be increased and users may experience lower
data speeds.

Verizon ASK-SFE116 Specifications

General

Brand	Verizon
Model	ASK-SFE116
Category	Extender
Language	English