GETTING TO KNOW THE VERIZON
INTERNET GATEWAY
1.1a/ RESET BUTTON
The reset button allows you to reset the gateway back to it’s factory
default state. Using the reset function will revert all settings and changes
made during the setup process. To perform a factory reset and return the
Verizon Internet Gateway to default settings, press and hold the reset button
for 3+ seconds. The System LED will flash yellow to indicate a reset has been
triggered, followed by fading in/out (white) while the gateway restarts.
1.1b/ WPS
WPS is an easy way to add supported Wi-Fi devices to your network. Press
the WPS button on the back of the Gateway to activate WPS. You will need to
activate WPS on your Wi-Fi device too. Refer to “3.1d/ Wi-Fi Protected Setup
(WPS)” on page 37.
1.1c/ LEDS
The LEDs indicate the system and connection status, and WPS activity.
Front LED Mode Status LED Pattern
System Status (O)
Bootup
System booting Soft blink white
Firmware update Fast blink white
Other
Factory reset Fast blink yellow
Hardware error Soft blink red
No SIM card Hard blink red
No signal Solid red
Note: System status LED will turn o when the Gateway is connected to the
network and signal bars turn ON.
To Next Page
Loading...
Need help?
General
