Frequently Asked Questions
Q: Are the 5000 series harnesses interchangeable between all other Networkfleet
product lines?
A: No.
Q: When installing the 5200 device, are fuses involved or can the device be “wired hot”?
A: We recommend splicing the 5200 harness to fused leads, though the device can be “wired hot” since there is an
internal re-settable fuse. An in line fuse is not necessary, however if one is used, it should be at least 5 amps.
Q: Can the window-mount GPS antenna be installed in the A-Pillar?
A: No, the antenna is designed so that it will only function properly with a clear view of the sky which is best achieved
by placing it on the glass windshield.
Q: I need to do a unit transfer. Can I re-use the window-mount GPS antenna? How do I remove it from the glass?
A: Yes, however the adhesive on the antenna is one-time use only and will not function properly after it is removed.
Re-installation kits are available - contact Customer Care at 866.227.7323 for more information.
Instructions for Window-Mount GPS Antenna Removal
Because of the strength of the antenna adhesive, use a razor or Goo Gone (a household solvent) for removal.
1. To remove the antenna with a razor, peel a small section of the antenna off of the glass and slide the razor
between the glass and the antenna.
2. Using a sawing motion, carefully remove the antenna from the glass and discard.
To Next Page
Loading...
