20
UVS27 Vent-Free Gas Heater
20007068
The combustor should be cleaned annually to ensure
optimal performance. Follow the procedure below.
Be sure the heater is COLD.
Remove the screws and washers holding the com-
bustor in place. Lift combustor up and out.
1. Clean the outer surface of the filter with the brush
attachment of your vacuum cleaner to remove loose
dirt.
2. Submerge the filter in a mild soapy water solution.
Rinse thoroughly with
3. Replace in heater when dry.
Replace combustor on top of firebox.
Secure with screws and washers removed earlier.
Refer to Page 11, Figure 15.
To Next Page
Loading...
Need help?
General
