Vernacare Vortex - Page 32

32
Machine will
NOT
start
Interlock not functioning.
Lid does not remain
closed.
Ensure that the lid is fully closing and
the handle is fully engaged.
Ensure that the interlock actuator
operates when the lid is closed.
Check display icon shows lid closed
& no boot symbol.
Check magnet on handle insert is
present and unobscured.
Machine motor overload
tripped.
Display screen indicates
`Blocked Blades'
Display on the invertor
Indicates `OL`.
Cutter blade jammed – Clear &
reset
See section 1 regarding maximum
number of products to be disposed
of in one cycle.
Motor jammed – see fault 2.
Mechanical seal jammed – Clear
& reset.
Fault 1 Continued