The following sections describe the mandatory regulations that govern the installation and operation of the
VX-MD4024 .
List of Terms
Table 1 lists the terms used in this chapter.
Table 1 List of Terms
General Requirements
The sections that follow outline the mandatory regulations that govern the installation and
operation of the VX-MD4024 . You must adhere to these instructions so that your system meets
regulatory requirements.
Prevention of Access
The VX-MD4024 must be accessible only to authorized personnel. Install this apparatus in a
restricted access location or similar environment to prevent unauthorized access.
Laser Interface
The VX-MD4024 uses Class I lasers as optical transmitter sources which are inherently safe
unless mishandled. The radiation from laser diodes is much more intense than other light sources
radiation. Only trained operating personnel thoroughly familiar with laser radiation hazards should
install or remove the fiber optic cables in this system.
EMC Compliance
EMC compliance may require the use of ferrites, shielded cables or other special accessories.
Where required, these special accessories must be installed as per the instructions.
To Next Page
Loading...