20 www.versitron.com
Cold Start
When the power to the system is turned on, the system-start initialization and self-test process starts up. The self-
test messages are displayed as follows if a console connection is established successfully:
Power-on Self-test
------------------------------------------------------
$$$ System LOADER Checksum O.K !!!
$$$ System IMAGE Checksum O.K !!!
$$$ Sytem DATA Checksum O.K !!!
$$ Waiting Copy Rom to Sdram
$$$ System Power On Self Test....
$$$ ARM Reg R/W Test Success !!!
$$$ System EEPROM Checksum O.K !!
$$$ Get parameter O.K !!
My Mac Address is xxxxxxxxxxxx
------------------------------------------------------
This chapter describes the detailed console operation. It can be applied to either out-of-band console management
or in-band Telnet management. Both are the same in operation starting from the login prompt.
Direct Console Management
When you see the self-test messages shown on the screen properly, you can press <Enter> to start the console
login operation. Go to the Login Prompt section below.
Telnet Management
Use Telnet software to perform the management operation. The most convenient solution is using the built-in
Telnet function in a Windows 95/98/ or NT PC. Enter into the DOS window and invoke the following Telnet
command to connect to the system unit:
>telnet xxx.xxx.xxx.xxx
The specified xxx.xxx.xxx.xxx is the IP address of the system unit. A welcome message and login prompt are
displayed if the connection is established properly.
Login Prompt
The following figure illustrates the login screen:
------------------------------------------------------
Welcome to Console
login:admin
password:***
------------------------------------------------------
Username: admin
Factory default Password: 123
For security reason, the system supports a function to change the pass- word in setup menu. It is recommended to
change the default password immediately after a successful login.
To Next Page
Loading...