EVX-539 OpErating Manual22
Fm scan
(
FolloW-mE scan
)
The FM Scan feature checks a user-assigned priority
channel regularly as you scan other channels. Thus,
if only Channels 1, 3, and 5 (of the 8 available chan-
nels) are designated for “Scanning”, the user may
nonetheless assign Channel 2 as the “user-assigned”
priority channel via the FM Scan.
To activate FM Scan, first select the channel you
want to designate as the “user-assigned priority chan-
nel” and press, (or press and hold), the assigned
PF
key. The display indicates “FM SCAN” briey. Then
rotate the
CH
Selector knob to recall to the “Scan-
ning Start” channel which has been programmed by
your dealer to activate the scanner. When the scan-
ner stops on an “Active” channel, the user-assigned
priority channel will automatically be checked every
few seconds; if activity is found on the user-assigned
priority channel, the radio will switch between it and
the dealer-assigned priority channel, if any.
scan sEt
Press, (or press and hold), the assigned
PF
key to add/
delete the current channel to/from your scanning list.
To store a particular channel to your scanning list,
press, (or press and hold), the assigned
PF
key; the
display indicates “-SCN SET-” briey and “ ” icon
will appear on the display. If you delete a channel
from your scanning list, press, (or press and hold), the
assigned
PF
key again; the display indicates “-SCN
SKIP-” briey and the “ ” icon will disappear from
the display.
When the scanner is stopped, you may remove the
channel from the scan list temporarily by pressing, (or
press and holding), the same key.
group scan sEt
You may wish to have the Scanner pass through more
than one Group during the scanning process (normally,
scanning is performed within the current group only).
To include the current Group in the scanning loop,
press, (or press and hold), the assigned
PF
key (the
“
” icon will appear on the display). To remove a
current Group from Group Scan, press, (or press and
advancEd opEratIon
To Next Page
Loading...
