VX-150 OPERATING MANUAL14
TONE CALLING
(
1750 Hz
)
If the repeaters in your country require a 1750-Hz burst tone for access (typically in Eu-
rope), you can set the MONI key to serve as a “TONE CALL” switch instead. To change the
configuration of this switch, we again use the Menu to help us.
Press the
[
F
]
key, then press the
[
0
(
SET
)
]
key to enter the Set mode.
Rotate the DIAL to select Menu Item #19 (“MON/TCL”).
Press the
[
F
]
key to enable adjustment of this Menu item.
Rotate the DIAL to select “T.CALL” on the display.
Press the PTT key to save the new setting and exit to normal operation.
ANI OPERATION
(
AUTOMATIC NUMBER IDENTIFICATION
)
When you activate the ANI feature, the DTMF tones stored in ANI memory will automati-
cally be sent whenever you press the PTT button.
Here is the ANI storage procedure:
Press the
[
F
]
key, then press the
[
0
(
SET
)
]
key, to enter the Set mode.
Rotate the DIAL to select Menu #36 (“ANI”).
Press the
[
F
]
key to enable changing of this Menu item.
Press the
[
F
]
key, then press the
[
F/W
]
key again, to begin entry of the letters and
numbers in the ANI code.
Rotate the DIAL to select the first letter or number in the ANI code. When the correct
character has been selected, press the
[
s
]
key to move on to the next character.
Repeat step
as many times as necessary to complete the ANI code.
When you have completed entry of the ANI code, press the
[
F
]
key.
Press the PTT key to save the settings and exit to normal operation.
To activate the ANI identifier:
Press the
[
F
]
key, then press the
[
0
(
SET
)]
key, to enter the Set mode.
Rotate the DIAL to select Menu #36 (“ANI”).
Press the
[
F
]
key to enable changing of this Menu item.
Rotate the DIAL to set the ANI function ON.
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
Advanced Operation
To Next Page
Loading...
