VX-2100/-2200 SERIES OPERATING MANUAL12
GROUP SCAN
(
This function is only available in the VX-2200
)
The Scanning feature is used to monitor multiple channels programmed into the
transceiver. While scanning, the transceiver will check each channel of the pro-
grammed group for the presence of the signal, and will stop on a channel if a signal
is present.
Press (or press and hold) the assigned programmable key to activate the scanning on
the selected groups.
GROUP SCAN SET
(
This function is only available in the VX-2200
)
You may wish to have the Scanner pass through more than one Group during the
scanning process (normally, scanning is performed within the current group only).
To include the current Group in the scanning loop, press (or press and hold) the
assigned programmable key. To remove a Group from Group Scan, press (or press
and hold) the assigned programmable key again.
DUAL WATCH
(
DW
)
The Dual Watch feature is similar to the SCAN feature, except that only two chan-
nels are monitored:
The current operating channel; and
The Priority channel.
To activate Dual Watch:
Press (or press and hold) the assigned programmable key.
The scanner will search the two channels; it will pause each time it finds a
channel on which someone is speaking.
To stop Dual Watch:
Press (or press and hold) the assigned programmable key.
Operation will revert to the “Dual Watch Start” channel.
ADVANCED OPERATION
To Next Page
Loading...
Need help?
General
