Vertex Standard VX-261 - Low Battery Indication

VX-261 Operating Manual
7
beFore You begin
batterypack.Ifchargingwiththetransceiverattached,
turnthetransceiveroff.Theantennajackshouldbeat
theleftsidewhenviewingthechargerfromthefront.
r
If the battery pack is inserted correctly, the LED in-
dicatorwillglowred.Afully-dischargedbatterypack
will charge completely in1.5 - 3.0 hours(depending
onthebatterypackbeingcharged).
r
 When charging is completed, the LED indicator will
changetogreen.
r
 Disconnectthebatterypackfromthe
CD-58
Desktop
Chargerand unplugthe
PA-55
ACAdapter fromthe
AClineoutlet.
1) Always use the Vertex Standard FNB-V133LI-
UNI or FNB-V134LI-UNI Lithium-Ion Battery
Pack.
2) Use only the Vertex Standard CD-58 Desktop Charger
and the Vertex Standard PA-55 AC Adapter.
3) To reduce the risk of explosion, recharge the batteries
outside of hazardous locations.
4) Perform the battery charging where the ambient tem-
perature range +41 °F to +104 °F (+5 °C to +40 °C).
Charging outside of this temperature range could cause
damage to the battery pack.
5) Battery Pack should not be exposed to excessive heat
such as sunshine, re, or similar heat sources.
6) Risk of explosion exists if battery is replaced by an
incorrect type. Refer to the enclosed instructions for dis-
posal of used batteries.
7) For further details and cautions of the charging, refer
to the Operating Manual of the CD-58 Desktop Charger.

Asthebatterydischargesduringuse,thevoltagegradually
becomes lower.When the battery voltage becomes too
low,substituteafreshlychargedbatteryandrechargethe
depletedpack.TheLEDindicatoronthetopoftheradio
willblinkredwhenthebatteryvoltageislow.
CAUTION
Dangerofexplosionifbatteryisreplacedwithan
incorrect battery. Replace only with the same or
equivalenttype.