FCC ID: K6610354640
IC ID: 511B-10354640
Alignment
6
/
10
Vertex Standard Co., Ltd.
Noise SQL Tight <Narrow> (TI NSQ N)
This parameter is to align the Noise SQL Tight level at Narrow (2.5k).
a. Press the “Start” button to start the alignment.
b. Set the Signal Generator according to the indication, then press “OK”.
c. Press the “OK” button after finish the adjustment, then the data will be saved and the
alignment is accomplished.
Noise SQL Threshold < Narrow > (TH NSQ N)
This parameter is to align the Noise SQL Threshold level at Narrow (2.5k).
a. Press the “Start” button to start the alignment.
b. Set the Signal Generator according to the indication, then press “OK”.
c. Press the “OK” button after finish the adjustment, then the data will be saved and the
alignment is accomplished.
RSSI SQL < Narrow > (RSSI SQL N)
This parameter is to align the RSSI SQL Tight level at Narrow (2.5k).
a. Press the “Start” button to start the alignment.
b. Set the Signal Generator according to the indication, then press “OK”.
c. Press the “OK” button after finish the adjustment, then the data will be saved and the
alignment is accomplished.
TX SAVE <Narrow> (TX Save N)
This parameter is used for only portable radio.
This parameter is to align the RSSI level for TX save function at Narrow (2.5k).
a. Press the “Start” button to start the alignment.
b. Set the Signal Generator according to the indication, then press “OK”.
c. Press the “OK” button after finish the adjustment, then the data will be saved and the
alignment is accomplished.
6. TX Power
High
(High power version: VHF 50 W/UHF 45 W, Mid power version: 25 W)
This parameter is to align TX High power.
a. Press the “Start” button to start the alignment then the radio will transmit.
b. Set the value to get desired output power on the Power Meter by changing the Scroll Bar
on your PC.
c. Press the “OK” button to save the alignment data and the alignment is accomplished.
Low3
(High power version: 25 W, Mid power version: 12.5 W)
This parameter is to align TX Low3 (LH) power.
a. Press the “Start” button to start the alignment then the radio will transmit.
b. Set the value to get desired output power with the Power Meter by changing the Scroll Bar
on your PC.
c. Press the “OK” button to save the alignment data and the alignment is accomplished.
This parameter is used to align TX Low3 (LH) power.
Low2
(High power version: 10 W, Mid power version: 5 W)
This parameter is to align TX Low2 (LM) power.
a. Press the “Start” button to start the alignment then the radio will transmit.
b. Set the value to get desired output power with the Power Meter by changing the Scroll Bar
on your PC.
c. Press the “OK” button to save the alignment data and the alignment is accomplished.
Low1
(High power version: Not Used, Mid power version: 1 W)
This parameter is to align TX Low1 (EL) power.
To Next Page
Loading...
Need help?
General
