Vertex Standard VX-451 - Advanced Safety Features

VX-450 SerieS Operating Manual
34
adVanced operatIon
Id cHecK
(
Vx-454 & Vx-459 only
)
This function allows logged ID of the DTMF Signal-
ing and 5-tone Signaling to be reviewed and relayed
(5-tone Signaling only) to a specic station:
r
Press (or press and hold) the assigned program-
mable key to display the logged ID of the DTMF
Signaling and 5-tone Signaling.
r
Press the
[
A
]
key to select the category (“DTMF
Signaling” or “5-tone Signaling”) to be reviewed,
then press the
SIDE-1
/
SIDE-2
keys to select the
ID.
r
Press the
[
B
]
key to toggle the display between
the “ID code display” and “Tag display”.
r
Press the
[
D
]
key to send the Call back, when
recalling the ID of the “5-tone Signaling”, if de-
sired.
You may cancel the Call back sending by press-
ing the
[
C
]
key. In this case, the display indicates
“
- CANCEL -
” briey.
arts logIn
(
Vx-454 & Vx-459 only
)
This function enable the displaying the logged ID of
the MDC1200 ARTS
TM
(ARTS
TM
II).
r
Press (or press and hold) the assigned program-
mable key to display the number of the logged
station of the MDC1200 ARTS
TM
(ARTS
TM
II).
r
Press the
SIDE-1
/
SIDE-2
keys to display the ID.
optIon sWItcH 1
Activates the optional accessory “1” while pressing
the assigned Programmable key.
optIon sWItcH 2
Press (or press and hold) the assigned Programmable
key to toggle the optional accessory “2” “On” and
“Off.”
rec
(
requIres tHe dVs-8 or dVs-9
)
Press (or press and hold) the assigned Program-
mable key to enable the Voice Recording Mode. If
the incoming signal is received, so as to un-mute
the squelch and pass audio, then the “ ” Icon will
ash
ø
and received audio will be recorded. When the
voice recording is completed, the “ ” stays on
ø
.
ø
:
VX-454
and
VX-459
Only.