Liebert Trinergy™ Cube OPERATING INSTRUCTIONS
Page 16 User Manual - 10H52243UM60 - rev. 6 - 12/2020
The UPS will switch to the “System in bypass” condition only when all the “STOP” buttons have been
pressed.
Under these conditions the load is supplied by the bypass, and all automatic functions, including battery
operation, are disabled.
3.5. Operating mode selection
In the default configuration, Trinergy™ Cube can select any of the available operating modes, depending
on external conditions. The UPS can be reconfigured to exclude certain operating modes. The system
may be configured by authorized service personnel only, upon request by the customer.
To Next Page
Loading...
Need help?
General