Vertiv | NetSure 7100 Series Quick Start Guide (QS582127000) | Rev. T
Make Controller Ethernet Connection (if required)
If the Web Interface will be used, connect to the Ethernet port on the front of the Controller. Location is shown
in Figure 36.
Refer to External Alarm, Reference, Monitoring, and Control Connections in the MAKING ELECTRICAL
CONNECTIONS section of the Installation Instructions (IM582127000) for Ethernet connection details.
NOTE!
You can access the Web pages of the power system locally by using a "crossover" or “straight”
cable connected directly between your PC and the controller.
Figure 36:
Controller Ethernet Port
NOTE!
NCU ONLY: If your system has an IB4 board, DO NOT connect your Local Area Network (LAN)
to the NCU front Ethernet port. See “NCU Controller Second Ethernet Port Connection (if IB4 board
furnished)” on page 75.
ESC EN
T
NCU
ACU+
10/100M Ethernet
Port (RJ-45)
10/100M Ethernet
Port (RJ-45)
ESC ENT
To Next Page
Loading...
