STATIC WARNING
This equipment contains static sensitive components. The warnings listed below must be
observed to prevent damage to these components. Disregarding any of these warnings may
result in personal injury or damage to the equipment.
1. Strictly adhere to the procedures provided in this document.
2. Before touching any equipment containing static sensitive components, discharge all static
electricity from yourself by wearing a wrist strap grounded through a one megohm resistor.
Some wrist straps have a built-in one megohm resistor; no external resistor is necessary.
Read and follow wrist strap manufacturer’s instructions outlining use of a specific wrist strap.
3. Do not touch traces or components on equipment containing static sensitive components.
Handle equipment containing static sensitive components only by the edges that do not have
connector pads.
4. After removing equipment containing static sensitive components, place the equipment only
on conductive or anti-static material such as conductive foam, conductive plastic, or
aluminum foil. Do not use ordinary Styrofoam
™
or ordinary plastic.
5. Store and ship equipment containing static sensitive components only in static shielding
containers.
6. If necessary to repair equipment containing static sensitive components, wear an
appropriately grounded wrist strap, work on a conductive surface, use a grounded soldering
iron, and use grounded test equipment.
To Next Page
Loading...
Need help?
General
