Purpose of the Document
This document applies to the VRC1 series of cooling solutions which maintain an optimal environmental
control mainly for technological ecosystems at minimal operating costs. This document gives an overview
of the technical specification. The figures used in this document are for reference only. Please read this
manual carefully.
Important Safety Instructions
The important safety instructions that should be followed during the installation and maintenance of the
VRC-Self-contained rack cooler are described in the following sections.
Read the manual prior to installation and operation of the unit. Only qualified personnel should move,
install, or service this equipment.
The user reads all of the precautions, compliance, and safety measures before working on the equipment.
The unit control must be used exclusively for the purpose for which it is intended; the manufacturer takes
no liability for incorrect use or modification to the unit control.
This manual is retained for the entire service life of the machine. The user must read all of the precautions,
danger, warnings, and cautionary measures mentioned in the manual prior to carrying out any operations
on the machine. Before performing any maintenance operation, switch off the machine to eliminate risks
such as electrical shocks, burns, automatic restarting, moving parts, and remote control.
Adhere to all the Warnings and Cautionary measures included in this manual. In the following sections,
look at the various cautionary measures and warnings that need to be read carefully prior to installing or
operating the system.
WARNING! Only trained and qualified personnel must be allowed to install, maintain, and
operate the unit.
WARNING! The sharp edges, sharp angles of the object, and bare buckle can result in severe
injury. Only properly trained and qualified personnel wearing appropriate, OSHA-approved PPE
should attempt to move, lift, remove packaging from or prepare the unit for installation.
WARNING: Risk of unit falling over. Improper handling can cause equipment damage, injury or
death. Read all the guidelines pertaining to the system before unpacking, moving, lifting or
installing the components. Read the labels on the unit carefully to understand the safety
measures prior to handling the containment.
WARNING! Risk of electric shock. Can cause injury or death. Open all local and remote electric
power-supply disconnect switches and verify that power is Off with a voltmeter before working
within the condensate pump electrical connection enclosure. The Liebert® controller does not
To Next Page
Loading...
Need help?
General