02_03
Starting up the engine (02_03)
The scooter is fitted with automatic transmission with a regulator and centrifugal clutch.
Therefore always start the engine with the throttle at a minimum; to start-off from still,
progressively twist the throttle grip.
The vehicle is equipped with a fuel valve and a starter that switch on automatically as
soon as the engine is started.
In order to start the engine, it is necessary to pull either the rear brake lever "B" or the
front brake lever "C", before pressing the starting button, "A ", so as to disengage the
safety switches.
1: Put the motorscooter on its stand "E"; check that the rear tire is off the ground.
2: Keep the throttle closed.
3: Insert the key into the ignition switch, "D", and turn to the ON position.
4: Push the starter button «A» after pulling the rear brake lever «B» or the front brake
lever «C».
CAUTION
DO NOT CARRY OUT THESE OPERATIONS IN CLOSED AREAS SINCE EX-
HAUST GASES ARE TOXIC.
CAUTION
DUE TO THE HIGH TEMPERATURES THE CATALYTIC CONVERTER CAN
REACH, ALWAYS TAKE CARE, WHEN PARKING THE SCOOTER, THAT THE
EXHAUST DOES NOT COME INTO CONTACT WITH FLAMMABLE MATERIALS,
TO AVOID SERIOUS BURNS.
19
To Next Page
Loading...
Need help?
General