— “built-in” units draw air from right of ventilation frame and expel through left of
ventilation frame under the front door.
— “built-in” refrigerators and beverage centers have a power switch located on
the control panel so power point location is not critical.
— The unit requires a standard 120 volt power point.
— The power cord is 1 m in length and is fixed on the right side at the back when
looking from front of refrigerator.
— As with most appliances of today, the refrigerator has sensitive electronic
components which are susceptible to damage through lightning and electricity
supply faults. It is therefore advised to use a power surge protector to avoid
problems of this nature.
— Air vent on door must be provided for any built-in wine unit when a wood door is
installed in front of the unit.
Electrical Connection
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized service center.
This appliance should be properly grounded for your safety. The power cord of
To Next Page
Loading...
