and work around setting temp within range of ± 2°. Under the circumstances of
power stop or cutting in the process of normal operation, the last setting figure can
be automatically memorized by the refrigerator.
Light ON/OFF: There is a light on the top of refrigerator.The light is controlled by
door pressure switch.
For the single temp fridge,when both drawers are closed, the light goes off
automatically, and when either drawer is pulled out, the light goes on.
For the double temp refrigerator, the light goes off automatically when the top
drawer is closed, lights go on when the top drawer is pulled out.There is no light
inside the bottom drawer.
To change the temperature display: The temperature displayed can be in
Fahrenheit or Celsius. Press the ℃/°F button to switch between °F and °C.
Service and Preservation Temperature
We recommend that the refrigerator be installed in a place where the ambient
temperature is 1ºC ~ 32ºC(34ºF ~ 89ºF). If it is used for a short time, the
refrigerator can also be placed in an environment of 43℃. However, if the ambient
temperature is higher than 32℃, the refrigerator performance may be affected. For
example, the internal temperature may fluctuate and the refrigerator may fail to
reach the set temperature.
Temperature Settings
IMPORTANT: The LED displays by default the actual internal air temperature.
The temperature settings are pre-set at the factory as follows. In the event of a
power interruption, all previous temperature settings are automatically erased and
it will revert to the pre-set temperature settings. The electrical board of all models
comes with memory function.
It is important to understand that there is a difference between the air temperature
inside the refrigerator and the actual temperature of the drinks: You will need to
wait approximately 3 hours before noticing the effects of temperature adjustment
due to the critical mass within a full refrigerator.
To Next Page
Loading...
